GE JV247 Series Owner's Manual And Installation Instructions page 11

Installation Instructions
i-8-IFOR 3-1-4" × I0" RECTANGULAR
DUCTED DISCHARGE INSTALLATIONS
ONLY:
Attach exhaust adaptor/damper over the appropriate
knockout opening (for vertical or horizontal, depending
on installation) with two exhaust adaptor screws. Make
sure damper pivot is nearest to top/back edge of hood.
Remove tape from damper flap.
Exhaust adaptor/damper
(vertical discharg_ position)
Pivot
(depending on
installation)
Top/back edge
Exhaust adaptor/damper
(horizontal discharge position)
ITO]FOR RECESSED-BOTTOM CABINETS
ONLY
Wood shims
(minimum thickness 3/8")
. If the cabinets have front, side or back trim, make
2 wood shims a minimum of 3/8" thick and cut to fit
the width of the inner recessed cabinet bottom. Attach
them to the cabinet bottom recess on both sides. See
Step !1 for marking locations.
@ FOR 7" ROUND VERTICAL DUCTED
DISCHARGE INSTALLATIONS ONLY:
Bend up the duct alignment ears in preparation for
later attachment of the 7" duct.
11