GE JV247 Series Owner's Manual And Installation Instructions page 13

Installation Instructions
[] SCREW IN PART WAY
Drive a mounting screw (from the hardware packet)
part way into each center of the narrow neck of the
keyhole slots marked on the cabinet bottom.
I-_ OPTIONAL POWER CORD
KIT JXHC1
An optional Power Cord Connection Kit, model
JXHC1, is available at extra cost from your
GE supplier for installation using a standard
3-prong, grounded wall outlet. Follow the
Installation Instructions packed with the kit to
connect the power cord to the range hood.
Cabinet
]-prong
(if using cord
connection)
1¾" dia. clearance hole
for optional power
supply location
NOTE: If using optional Power Cord Kit JXHC1, feed
the power cord through the hole in the top cabinet
while raising the hood. Loop any excess length of
cord and tie away with a suitable tape or tie.
I-_ FEED IN WIRES
Lift the hood into position and feed the house wiring
through the wiring knockout.
[] SECURE HOOD
Slide the hood back against the wall. Tighten the
mounting screws. Be sure the screw heads are in
the narrow neck of the keyhole slot.
NOTE: DO NOT PUSH ON THE FAN BLADE.Pushing on
the blade may cause it to interfere with other hood
parts.
[] CONNECT DUCTWORK TO HOOD
(Ducted instullations only)
On 7" round installations, attach the 7" duct
with sheet metal screws through the holes in the
alignment ears.
L__.J_--- 7" round duct
Use duct tape to make joints secure and airtight.
Du
1]