GE JV247 Series Owner's Manual And Installation Instructions page 12

Installation Instructions
[] MARK HOLES
Select the vent option that your installation will require
and proceed to that section:
A.Outside top exhaust
(Vertical duct-3-1/4" x 10" Rectangular)
. Use the diagram or the hood as a template and mark
the locations on the cabinet for ductwork, electrical
wiring and keyhole screw slots.
Hood mounting screws (4)
10sA" (2W' hood)
133A" (30" hood)
:]_03_ '' (24" hood)
133A '' (30" hood)
163A '' (36" hood)
shims
(recessed-bottom
cabinets only-shims
must be a minimum
of 3/8" thick and cut
to fit the width of
the inner recessed
cabinet bottom)
Electricalaccess hole
Center (in cabinet bottom)
line
B. Outside top exhaust (Vertical duct-7" Round)
. Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Hood mounting screws (4)
i0¾" (24" hood) i0_/' (24" hood)
13¾" (30" hood) 13_/' (30" hood)
(36"
Access
hole for
round duct
Wood shims (recessed-
bottom cabinets only-shims
Center
must be a minimum of 3/8"
line
thick and cut to fit the width
of the inner recessed cabinet
bottom)
Electrical access
hole (incabinet b ottom)
C.Outside rear exhaust
(Horizontalduct-3-1/4" x 10" Rectangular)
. Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Wood shims
(recessed-bottom cabinets only-shims must be
a minimum of 3/8" thick and cut to fit the width
of the inner recessed cabinet bottom)
½,, 1_/' ] | I
Cabinet front
Cabinet ± _ _ I _'_, 1
bottom l_--s¼" _ _--s_" _4 I
J-_---10s/4" 124" hood)--_ _---10¾" 124" hood)---_
--'_13_' 130" hood) 13sA '' 130" hood)
16YJ' 136" h ood) 16_"136" hood)
Hood mounting Center line Electrical access
screws (4) hole (inwall)
D. Recirculating (non-vented ductless-
JN327 and RN328, and optional on JV247,
JV248, JV347, JV348, JV367 and AV447
models
only}
. Use the hood as a template and mark the locations
on the cabinet for the electrical wiring and keyhole
screw slots.
, Since the hood is to be recirculated (not to be vented
outside), do not cut out any vent openings in the wall
or cabinet bottom.
CUT HOLES
Cut holes at marked locations for duct and electrical
wiring. For the vertical duct, cut out 3/4" extra toward
the front of the cabinet so you can move the duct
freely when installing the hood. It may also ease
installation by cutting the hole 10W' instead of !0".
[_ RUN WIRES
Run the electrical wires through the wall or cabinet
according to National Electrical Code and applicable
local codes.
NOTE: DO NOT turn the power on until installation is
complete.
12