Before Use; Set Date And Time; Check For Dial Tone - VTech CS6648-3 User Manual

Battery
indicators
The screen The battery
is blank, or has no or
displays Put very little
in charger charge. The
and flashes. handset
cannot be
used.
The screen The battery
displays has enough
Low battery charge to
and flashes. be used
for a short
time.
The screen The battery
displays is charged.
HANDSET X.
When the battery is fully charged, you can
expect the following performance:
Operation
While in handset use
(talking*)
While in speakerphone
mode (talking*)
While not in use
(standby**)
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging or in use.
Battery Action
status
Charge
without
interruption
(about 30
minutes).
Charge
without
interruption
(about 30
minutes).
To keep
the battery
charged,
place it in
the handset
charger when
not in use.
Operating
time
Up to 7 hours
Up to 3.5 hours
Up to 5 days

Before use

After you install your telephone or power
returns following a power outage, the
handset will prompt you to set the date
and time.

Set date and time

NOTE
Make sure you set the date and time
including the year correctly; otherwise the
answering system does not announce the
correct day of the week for your recorded
messages time stamp.
1. Use the dialing keys (0-9) to enter
the month (MM), date (DD) and year
(YY). Then press SELECT.
2. Use the dialing keys (0-9) to enter
the hour (HH) and minute (MM).
Then press
PM.
3. Press SELECT to save.

Check for dial tone

Press . If you hear a dial tone, the
installation is successful.
If you do not hear a dial tone:
• Make sure the installation procedures
described above are properly done.
• It may be a wiring problem. If you have
changed your telephone service to
digital service from a cable company
or a VoIP service provider, the
telephone line may need to be rewired
to allow all existing telephone jacks to
work. Contact your cable/VoIP service
provider for more information.
8
or to choose AM or