Connect The Charger; Mount The Telephone Base; Install And Charge The Battery; Before Use - VTech CS6114-2 User Manual

Connect the charger

Mount the telephone base

Install and charge the battery

Install the battery
Install the battery as shown below.
NOTES
• Use only supplied battery.
• Charge the battery provided with this
product only in accordance with the
instructions and limitations specified in this
manual.
• If the handset will not be used for a long
time, disconnect and remove the battery to
prevent possible leakage.
Charge the battery
Place the handset in the telephone
base or the charger to charge.
Once you have installed the battery, the
handset LCD display indicates the battery
status (see the following table).
NOTES
• For best performance, keep the handset in
the telephone base or charger when not in
use.
• The battery is fully charged after 16 hours of
continuous charging.
• If you place the handset in the telephone
base or the charger without plugging in the
battery, the screen displays No battery.
4
Battery Battery
THIS SIDE UP
indicators status
The screen The battery
is blank, or has no or
displays Put in very little
charger and charge. The
flashes. handset
cannot be
used.
The screen The battery
displays has enough
charge to be
Low battery
used for a
and flashes.
short time.
The screen The battery
displays is charged.
HANDSET X.
When the battery is fully charged, you can
expect the following performance:
Operation
While in use (talking*)
While not in use (standby**)
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging nor in use.

Before use

Action
After you install your telephone or power
Charge
returns following a power outage, the
without
handset will prompt you to set the date
interruption
(at least 30
and time.
minutes).

Set date and time

1. Use the dialing keys (0-9) to enter the
month (MM), date (DD) and year (YY).
Charge
Then press SELECT.
without
interruption
2. Use the dialing keys (0-9) to enter the
(about 30
hour (HH) and minute (MM). Then
minutes).
press q or p to choose AM or PM.
To keep
3. Press SELECT to save.
the battery
charged,
place it in the

Check for dial tone

telephone
base or
Press . If you hear a dial tone, the
charger when
installation is successful.
not in use.
If you do not hear a dial tone:
• Make sure the installation procedures
described above are properly done.
• It may be a wiring problem. If you have
Operating
changed your telephone service to
time
digital service from a cable company or
Seven hours
a VoIP service provider, the telephone
Five days
line may need to be rewired to allow
all existing telephone jacks to work.
Contact your cable/VoIP service
provider for more information.
5