Troubleshooting - Schwinn A40 Owner's Manual

Troubleshooting
Batteries
Problem
Nodisplay/ not fully displayed/ unit will not turn on
Consoledisplays"E2"errorcode
Check
Main consolecable integrity
Main consolecableconnections / orientation
Consoledisplayscracksor otherdamage
Display
The connections (if usingoptional powersupply)
Check data cable integrity
Check data cableconnections/orientation
ConsoleElectronics
Solution
Checkbatteriesandmakesurethey are installed
correctly.If installedcorrectlyandproblempersists,
replacebatteries.
Replace the cable if the wires arecrimpedor cut.
Makesurethe cable is connected correctlybehindthe
Consoleandat the baseof the ConsoleMast.
Replacethe Consoleif damaged.
Replacethe computerif the Consoledoesnot fully
display.
Connection mustbe secureandnot damaged.Replace
adapteror connectionat unit if damageshows.
All wires in cable shouldbe intact. If any arecut or
crimped,replacecable.
Make surethe cable is connectedsecurelyand
orientedproperly.Small latch on connector s houldline
up andsnapinto place.
If tests revealno other issues,Consoleshouldbe
replaced.
Nospeed/ RPMreading,Consoledisplays"Pedal" Main Consolecable integrity All wires in cablemustbe intact. Replace the cable if
error code the wires arecrimpedor cut.
Main Consolecableconnections position Make surethe cable is correctlypositionedand
connected.Thesmall latch on connectormustline up
andclick into position.
The Magnetposition(requiresshroudremoval) Replacethe Flywheel o r full primaryassemblyif you
RPM Sensor (requires shroud removal)
Main Consolecable integrity
PrimaryConsolecable connections / position
Magnetposition(requiresshroudremoval)
RPM Sensor (requires shroud removal)
Console shuts off (enters sleep mode)while in use
do not see a magnet.
RPMsensormustbe alignedwith magnetand
connected to datacable. Re-align sensorif necessary.
Replaceif thereis any damage to sensoror connecting
wire.
All wires in cablemustbe intact. Replace the cable if
the wires arecrimpedor cut.
Make surethe cable is correctlypositionedand
connected.Small latchon connector m ust line upand
click into position.
Replacethe Flywheel o r full baseassemblyif you do
not seea magnet.
RPMsensormustbe alignedwith magnetand
connected to datacable. Re-align sensorif necessary.
Replaceif thereis any damage to sensoror connecting
wire.
13