Sharp Aquos LC-45GD6U Operation Manual page 72

Useful adjustment settings
• Some input signals may have to be registered manually
to display properly.
• The pairs of input signals (resolutions) in the list below
are not distinguishable when received. In such case, you
have to set the correct signal manually. After setting once,
it will display when the same signal (resolution) is input
again.
640x 400 720x 400
640x 480 848 x 480
1024x768 1280 x 768
Press
./T
to select "3D Noise Reduction",
and then press ENTER.
Press
./T
to select the desired level, and
then press ENTER.
• You can only select the "Input Signal" on the Setup menu
when receiving one of the 6 input signals listed above.
IX)
Virtual @O
ICHQID
MENU
o~e
FAVORITE CH
0----®--@--®
Reduces fine detail mosquito noise.
Repeat steps 1 and 2 in 3D Noise
Reduction.
Press
./T
to select "Mosquito Noise
Reduction", and then press ENTER.
Press MENU and the MENU screen displays.
Press
~/~
to select "Setup".
I
It
Off
High
Low
Press
./T
to select the desired level, and
then press ENTER.
For normal images
For enhanced Mosquito Noise Reduction
For moderate Mosquito Noise Reduction
Press
./T
to select "Input Signal" and then
press ENTER.
Press
./T
to select the desired input signal
on the display.
Example
When listening to music from a music program, you
can set the Liquid Crystal display off and enjoy audio
only.
Repeat steps 1 and 2 in 3D Noise
Reduction.
Press
./T
to select "Audio Only", and then
press ENTER.
Press
~/~
to select "On", and then press
ENTER.
Produces a clearer video image.
• Press MENU and the MENU screen displays.
Press
~/~
to select "Option".
On
Off
Audio is output without screen image.
Both screen images and audio are output.
(@-71