LG WM3250HRA Owner's Manual page 14

14
INSTALLATION _NSTRUCTIONS
Connecting the Water Lines
Check the rubber seals on both sides of the hose
--insert a rubber seal into the threaded fittings on each
hose to prevent ieaking,
Rubber seal
4
Connect the hoses to the water iniets tightly by hand and
then tighten another 2/:3 turn with pliers_
Connect the blue hose to the cold water inWet a nd the
red hose to the hot water inlet.
water
inlet
inlet
2
3
hose
(% faucet}
'€,/ate r hose
(To water inlet on the
washing machine)
Connect the water supply hoses to the HOT and COLD
water faucets tightly by hand and then tighten another
2/3 turn with pliers,
o Connect the blue hose to a cold water faucet and the
red hose to a hot water faucet,
After connecting inlet hose to water faucets, turn on the
water faucets to flush out foreign substances (dirt, sand
or sawdust} in the water lines. Let water drain into a
bucket, and check the water temperature
5 Check for leaks by turning on the faucets,
- tf water {eaks, check steps t to 4 again,
NOTE ..............................
* Foryoursafety, and forextended productiife use
onlyauthorized c omponents The manufacturerisnot
responsible f orproductmaifunction or accidents caused
by theuse of separately p urchased unauthorized p arts_
, Use new hoses when you instali the washing machine
Do notreuse oldhose& Use onlythe inlet h oses
providedwiththewasher LG does notrecommend the
use ofaftermarket hoses
, Pedodicaiiy check the hoses for cracks, leaks and wear,
and replace the hoses every 5 years.
° Do not stretch the water hoses intentionally, and make
sure that they are not crushed by other objects.
, Watei supply pressure must be between 14,5 PSi and
116 PS_ (!00-_800 kPa), if the water supply pressure is
more than 116 PS!, a pressure reducing valve must be
installed.
° To provide optimum washing performance the hot
water temperature should be set at 120-135°F (48-67°C)
and the cold at 60°F (15°C),
. J