Westinghouse RTS Series Installation And Operational Manual page 59

If the scan attempt was unsuccessful, "Failed" will display on the LCD and 1N will not
change to 1Y. Repeat the steps above to try again.
Note: The same finger can be used for fingers 2 and 3. This is recommended for Users
with poor quality fingerprints. Usually, different fingers will be used for fingers 1, 2 and
3.
6) The sensor will flash 3 times.
Keep finger on the sensor while it
flashes.
"Capturing..." will be shown while
the FP is being scanned.
7) If finger 1 was successfully
enrolled, a single short beep will
be heard, the LCD will display
"Success," and "1N" will change to
"1Y."
8) Rest finger on sensor. Press
the Up Arrow to highlight "2N."
Press M.
Page 59