Westinghouse RTS Series Installation And Operational Manual page 14

1) Insert the Spindle though the
fixing plate and into the inside
section of the lock‟s spindle hole.
2) Place the rubber gasket onto
the inside section of the lock.
3) Insert the spindle spring into
the lock handle hole.
Note: Very Important
Note: There are 7 wires for direct
power, normally open, and RS485
devices. See Section 9 for
specifics. These can be removed
if they are not used or placed
inside the door for future use.
4) Feed the cable from the inside
lock through the opening in the
bottom side of the fixing plate.
5) Plug the cable into the lock.
Note: Be sure that the connector is
fully seated. Connect or hardwire
the other wires where applicable.
(See Section 9)
Page 14