1:1 Mode With A Registered Pin Code - Westinghouse RTS Series Installation And Operational Manual

If verification of the enrolled fingerprint is not successful, no beeps will be heard. If this
happens, re-position the finger on the sensor. The sensor will try two more times to
verify the enrolled fingerprint. If all three attempts fail, three short beeps will be heard.
Remove the enrolled finger and begin again. If the second attempt fails, make sure that
the finger being used has been enrolled.
If three short beeps are heard after * or # button was pressed, this indicates that the
matching mode is set to 1:1.
If one single beep is heard after a successful verification, this indicates that the user ID
is outside of Timed Access settings

6.4 1:1 Mode with a registered PIN Code

1) Enter the specific User ID on the keypad of the outside unit, Press *. Enter the
Registered PIN Code and then press *.
Example: User 50 with a PIN of 1234 would press 50 * 1234 *.
2) If PIN Code verification was successful, three short beeps will be heard, and the RTS
will unlock and remain unlocked for approximately four seconds.
If verification of the registered PIN Code was not successful, three short beeps will be
heard and the RTS will power off.
If a second attempt to unlock the door with a PIN code fails, verify that the PIN Code
has been registered. Also verify that the matching mode is set to 1:1.
If one single beep is heard after the PIN code was successfully entered, this indicates
that the user ID is outside of Timed Access settings6.5 With the override keys
3) If fingerprint verification is
successful, a single short beep will
be heard and the RTS will unlock. It
will remain unlocked for
approximately four seconds.
Page 21