Disable Led Blinking Or Turn Off Leds - NETGEAR Nighthawk X4S D7800 User Manual

Nighthawk X4S AC2600 WiFi VDSL/ADSL Modem Router Model D7800
To erase the settings:
1. Launch a web browser from a computer or WiFi device that is connected to the network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the modem router user name and password.
The user name is admin. The default password is password. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > Backup Settings.
The Backup Settings page displays.
5. Click the Erase button.
The configuration is reset to factory default settings. When the reset is complete, the modem router reboots.
This process takes about two minutes.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the reset. For example,
do not close the browser, click a link, or load a new page. Do not turn off the modem
router. Wait until the modem router finishes restarting and the Power LED turns solid
white.

Disable LED Blinking or Turn Off LEDs

The LEDs on the top panel of the modem router indicate activities and behavior. You can disable LED blinking for
network communications, or turn off all LEDs except the Power LED.
To disable LED blinking or turn off the LEDs:
1. Launch a web browser from a computer or WiFi device that is connected to the network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The default password is password. The user name and password are case-sensitive.
The BASIC Home page displays.
Manage the Modem Router and Monitor the Traffic
223