Epson SC-T7200 Series User Manual page 147

SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Item
Roll End Option
*1
Auto Loading
*1
Roll Switch Setting
Using the Control Panel Menu
Description
Continue Select the action to perform for a roll after replacement: print the
remaining data (Continue) / do not print (Stop Printing) / print
*
again from the beginning (Reprint).
Stop Printing
*3
Reprint
* Normally, leave the setting at On.
On
If you experience problems with automatic loading when you use
Off
commercially available paper because of lack of tension,
slipperiness, extremely large curls, or other problems, set to Off.
Remove all paper before configuring this setting. If paper is
loaded, the setting cannot be changed.
While the setting is Off, the Roll 2 unit cannot be used.
* Select the action to take when the roll currently in use is under the
Auto
following conditions: automatically switch between Roll 1 and Roll
2 and print (Auto) / print fixed to Roll 1 (Roll 1)/print fixed to Roll 2
Roll 1
(Roll 2).
Roll 2
❏
The roll is finished, and there is data still to be printed.
❏
The printer predicts that there is not enough roll paper
remaining, and printing cannot be completed.
❏
The print margin will be large for the width of the print job.
When the setting is Auto, the roll is switched according to the Roll
Switch Condition setting.
147