Wps - Hawking HW12ACM User Manual

WDS Functionality
Local MAC Address
WDS Peer Settings
WDS #
WDS VLAN
VLAN Mode
VLAN ID
WDS Encryption
Encryption

4-3-3. WPS

compatible devices. WPS can be activated on compatible devices by pushing a WPS button on the device or
from within the device's firmware/configuration interface (known as PBC or "Push Button Configuration").
When WPS is activated in the correct manner and at the correct time for two compatible devices, they will
automatically connect. "PIN code WPS" is a variation of PBC which includes the additional use of a PIN code
between the two devices for verification.
Please refer to manufacturer's instructions for your other WPS device.
53
Select "WDS with AP" to use WDS with access point or
"Dedicated WDS" to use WDS and also block communication
with regular wireless clients. When WDS is used, each access
point should be configured with corresponding MAC
addresses, wireless channel and wireless encryption method.
Displays the MAC address of your access point.
Enter the MAC address for up to four other WDA devices you
wish to connect.
Specify the WDS VLAN mode to "Untagged Port" or "Tagged
Port".
Specify the WDS VLAN ID when "Untagged Port" is selected
above.
Select whether to use "None" or "AES" encryption and enter a
pre-shared key for AES with 8-63 alphanumeric characters.
Wi-Fi Protected Setup is a simple way to establish connections between WPS