Hawking HWABN1 Quick Installation Manual

Part No. HWABN1 Hi-Gain
Start Here
1
Check Package Contents & Requirements

Package Contents

•1x Wireless-300N A/Bridge
•1x Power Adapter
•1x Ethernet Cable
2
Overview
3
Connecting the AP/Bridge
1.) Connect the A/C power adapter to an
electrical source, and then connect it to the
'Power' socket of the AP/Bridge.
HWABN1
AP/Bridge
4
Configuring the AP/Bridge
1.) Insert the Setup CD into the
CD-ROM drive of your computer.
2.) When the auto-load page
appears, click the Setup Wizard
option on the right and follow the
Setup directions...
TM Wireless-300N Access Point/Bridge
•1x Setup CD -ROM
•1x QIG (Quick Install Guide)
•2x Dipole Antennas
2.) Connect your AP/Bridge to your broad-
band router.
HWABN1
AP/Bridge
3.) Scan for your AP/Bridge by clicking
the 'Search' button. Once found, click
the device to highlight it and click
'Next".
QUICK INSTALLATION GUIDE
Requirements
•Internet Access with router or modem
•PC Computer (for configuration only)
•Power Outlet
Router/AP
Broadband Modem
"SOURCE"
4.) Here, you can adjust your LAN IP
address for the AP/Bridge. You can
automatically assign an IP from your
network, or you may also choose to set
it Manually. Click 'Next'.
3.) Connect your PC to any of the LAN ports
located on the back of your router/AP.
Router/AP
"SOURCE"
PC Symbol for Ethernet Port
5.) Select an Operation Mode. Choose
either Access Point Mode or Ethernet
Bridge Mode. Click 'Next'. See Step 5a
to continue operating in Access Point
Mode or Step 5b to continue operating
in Bridge Mode.
Broadband Modem
PC
Example
PC Rear Ports