Kawai MP11 Owner's Manual page 43

 A bout DCA Parameters
The DCA (Digitally Controlled Amplifier) parameters, are used to
adjust the volume level of a sound over time using an envelope.
The diagram below indicates the MP11's DCA parameters.
6
5
Key ON
16. Vibrate Depth
This parameter adjusts the depth of the vibration applied to
the selected sound.
18. Vibrate Delay
This parameter adjusts the delay time before the start of the
vibration.
19. Octave Layer Switch
This parameter turns the additional Octave Layer ON or OFF.
21. Octave Layer Range
This parameter sets the amount of octave transposition for the
Octave Layer.
23. Layer Vocal
This parameter adjusts the amount of Vocal sound that is added
to the selected sound.
25. Layer Air
This parameter adjusts the amount of Air sound that is added to
the selected sound.
MP11_EN_20140421_R102.indd 43
8
7
Key OFF Time
: –64 ~ +63
value
: –64 ~ +63
value
o , o
ff n
: –2 ~ +2
value
: o , 1 ~ 127
value ff
: o , 1 ~ 127
value ff
 A bout DCF Parameters
The DCF (Digitally Controlled Filter) parameters, are used to
adjust a low-pass filter applied to the sound over time.
The diagram below indicates the MP11's DCF parameters.
11
9
10
Key ON
17. Vibrate Rate
This parameter adjusts the speed of the vibration applied to
the selected sound.
20. Octave Layer Level
This parameter adjusts the volume level of the Octave Layer.
22. Octave Layer Detune
This parameter adjusts the tuning of the Octave Layer.
24. Layer Bell
This parameter adjusts the amount of Bell sound that is added
to the selected sound.
13
12
Key OFF Time
: –64 ~ +63
value
: 0 ~ 127
value
: –64 ~ +63
value
: o , 1 ~ 127
value ff

2014/04/22 8:48:55