Installing The Lcd Module - Toshiba NB300 Maintenance Manual

Error! Style not defined. Error! Style not defined.

Installing the LCD Module

Install the LCD module according to the following procedures.
NOTE: Take extra care in routing cables and antennas on the LCD module. Improperly
routed cables can become pinched or damaged and cause malfunction.
1. Turn the LCD module cover and place it face down on a protective surface such as a
foam pad.
2. Connect the LVDS cable to the LCD panel connector and adhere with tape.
3. Turn the LCD right side up.
4. Seat the LCD hinge assembly in the correct position beside the LCD panel and secure it
with four M2x3 screws.
5. Seat the LCD module in the correct position in the LCD cover assembly.
6. Secure the LCD module to the LCD cover assembly with four M2.5x4 screws.
7. Route all the cables and antennas carefully in the routing channel.
NB300 Maintenance Manual
4 Replacement Procedures
4-55