Toshiba NB300 Maintenance Manual page 160

Error! Style not defined. Error! Style not defined.
Note: If the thermal pad is broken, please follow the steps below to replace it with a thermal pad.
1. Remove the protection film (a transparent Mylar) from the thermal pad.
2. Stick the thermal pad on the motherboard in the correct position.
Figure 4.15 Stick the thermal pad on the motherboard in the correct position
3. Remove the sticker on the front side of the thermal pad.
Figure 4.16 Remove the sticker on the front side of the thermal pad
If the motherboard is replaced with a new one, there will be a new thermal stuck on the
motherboard. Please remove the sticker on the thermal pad before installing the memory module.
NB300 Maintenance Manual
Figure 4.14 Remove the protection film
4 Replacement Procedures
Transparent Mylar
Be noted solder
position
4-21