overview
using the numeric buttons
CHANNEL 1–9
CHANNEL 10
CHANNEL 11–16
Changing the remote Control id
Remote control's ID and NVR's ID should be matched for proper operation.
1. Press the [id] button of the remote control and check the ID displayed on the NVR screen.
The factory default ID of the remote control is 00.
2. Enter 2 digits of your selection in order, while pressing the [id] button of the remote control.
3. When ID input is done, press the [id] button of the remote control again to check the setting.
If you want to change the remote control ID to 08: Press 0 and 8 in order while the [ID] button of the remote control is
`
M
pressed.
For changing the ID of remote device, refer to "Remote Devices". (Page 85)
16_ overview
Press each button between 1 to 9.
Press the [+10] button first, then press the 0 button again within 3 seconds.
Press the [+10] button first, then press any number between 1 to 6 within 3 seconds.