Miele PG 8056 Operating Instructions Manual page 95

Problem
Fault 406-408
Fault 412-414
Check drainage
Fault XXX
(XXX stands for a number)
Possible cause and solution
Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too low and the program will be cancelled.
The flow pressure at the water intake point is too low

(see "Technical data"). Contact Miele Service for advice.
Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too high and the program will be cancelled.
The flow pressure at the water intake point is too high

(see "Technical data"). Contact Miele Service for advice.
The water outlet is restricted. There might be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").

Clean the drain pump (see "Frequently asked

questions").
Clean the non-return valve (see "Frequently asked

questions").
Remove any kink or loop in the drain hose.

There may be a technical fault.
After a 10 seconds:
Turn the dishwasher back on.

Select the desired program.

Press the Start/Stop button.

If the error message is displayed again, there is a technical
fault.
Contact Miele Service.

The waterproof system has reacted.
Close the faucet.

Contact Miele Service.

Frequently asked questions
95