Complete Installation - Maytag MDE18PD Installation Instructions Manual

COMPLETE INSTALLATION

1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended earthing method.
See "Electrical Requirements. "
2. Check that all parts are now installed. If there is an extra part,
go back through the steps.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
WARNING
Electric Shock Hazard
This dryer must be earthed.
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electric shock.
5. Plug into an earthed outlet, or connect power.
18
6. Check dryer operation. Close dryer door. Set the cycle.
Operating time will accumulate per number of coins.
Using a full heat cycle (not the air cycle), let the dryer run for at
least five minutes. Dryer will stop when time is used up. Make
sure the dryer turns off.
NOTE: Dryer door must be closed for dryer to operate. When
door is open, dryer stops, but timer continues to run.
7. Gas Models only: Open the dryer door. Check that the inside of
the dryer is warm. If the burner does not ignite and you can feel
no heat inside the dryer, shut off dryer for five minutes. Check
that all supply valve controls are in "ON" position and that the
electrical cord is plugged in. Repeat five-minute test.
8. If drying time is too long, make sure that the lint screen is clean
and that there are no obstructions to airflow in the dryer vent
system.
9. Restart the dryer and allow it to complete a full heat cycle
(not air cycle) to make sure it is working properly.