Complete Installation - Maytag MDE18CSAG Installation Instructions Manual

COMPLETE INSTALLATION

1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended earthing method.
See "Electrical Requirements. "
2. Check that all parts are now installed. If there is an extra part,
go back through the steps.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
WARNING
Electric Shock Hazard
This dryer must be earthed.
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electric shock.
5. Plug into an earthed outlet, or connect power.
18
6. Check dryer operation (some accumulated time may be
on the timer due to factory testing). Close dryer door. Insert
coins in slide and press slide in slowly. (Operating time will
accumulate per number of coins and type of timing cam used.)
Push START button. Using a full heat cycle (not the air cycle), let
the dryer run for at least five minutes. Dryer will stop when time
is used up.
NOTE: Dryer door must be closed for dryer to operate. When
door is open, dryer stops, but timer continues to run. To restart
dryer, close door and push START button.
7. Gas Models only: Open the dryer door. Check that the inside of
the dryer is warm. If the burner does not ignite and you can feel
no heat inside the dryer, shut off dryer for five minutes. Check
that all supply valve controls are in "ON" position and that the
electrical cord is plugged in. Repeat five-minute test.
8. If drying time is too long, make sure that the lint screen is clean
and that there are no obstructions to airflow in the dryer vent
system.
9. Restart the dryer and allow it to complete a full heat cycle
(not air cycle) to make sure it is working properly.