Adsl Transmission Status - Sagem F@st 908 Reference Manual

SAGEM F@st
2.6.1

ADSL transmission status

The table below gives the meaning of the different fields and of the buttons.
Parameter Value
Modem not
responding
Searching for
modem
DSL Status
Training
Initializing
Operational
Transmit
Data rate
Receive
Off
Bridge lock
On
See section
2.6.4
Auto / Minutes
Note: If this icon remains permanently red, check if a Firewall is activated (Firewall
provided with Windows XP or software external to your computer). In this case,
you have to parameter it to make your modem operational. To allow traffic, enter the
following characteristics :
- External Port number
- Internal Port number
- Transport layer Protocol
To set the firewall activated:
1) Firewall provided with Windows XP, refer to chapter 6 (appendice),
2) Software external to your computer, refer to appropriate documentation.
TM
908 / 948 Reference Manual - Ethernet Interface
Flag
Red
Red
Yellow
Green
Green
Green
Green
Green
Lock
Lock
: 3456,
: 3456,
: UDP.
14
Comment
The modem is not responding to requests
from the BridgeMon application (see note).
The BridgeMon application is looking for the
modem.
The ADSL connection is in progress.
The modem searchs the active VPI / VCI /
Encaps values, the PPPoE client can be
started up.
The modem is operational.
Maximum transmit ADSL rate in kbps.
Maximum receive ADSL rate in kbps.
The "Bridge Lock" function is not active; traffic
from the Internet is allowed.
The "Bridge Lock" function is active; traffic
from the Internet is blocked.
The modem has switched to "Bridge Lock"
mode automatically after N minutes idle. See
section 2.6.4.