Table of Contents
Advertisement
Installing the Memory
NOTE: Please use DIMM 2 slot if there is only one memory module available.
1.
Align the notch on the memory-card with the tab on the system-board connector.
2.
Press down on the memory module until the release tabs spring back to secure them in place.
3.
Install:
a.
system-board shield
b.
back cover
c.
optical-disk drive
d.
stand
4.
Follow the procedures in
Removing the System Fan
1.
Follow the procedures in
2.
Remove:
a.
stand
b.
optical-disk drive
c.
back cover
d.
system-board shield
3.
Perform the following steps as shown in the illustration:
a. Disconnect the system fan cable from the system board [1].
b. Remove the screws that secure the system fan to the computer [2].
4.
Remove the system fan from the computer.
14
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
Advertisement
Table of Contents
