Table of Contents
Advertisement
Installing the Power-Switch Board
1.
Connect the power-switch cable to the power-switch board. Insert the power-switch board into its
slot on the computer.
2.
Install:
a.
back cover
b.
optical-disk drive
c.
stand
3.
Follow the procedures in
Removing the System-Board Shield
1.
Follow the procedures in
2.
Remove:
a.
stand
b.
optical-disk drive
c.
back cover
3.
Perform the following steps as shown in the illustration:
a. Remove the screws that secure the system-board shield to the computer [1].
b. Lift the system-board shield from the computer [2].
c. Remove the system-board shield from the computer [3].
12
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
Advertisement
Table of Contents
