Playback - Checking The Recording; Preparing For Playback - Sony SRW-9000PL Operation Manual

Playback – Checking the
Recording
You can view playback video by pressing the
PLAY button. Playback video appears in the
viewfinder, and on monitors connected to the HD
SDI MON1 connector, the HD SDI MON2
connector, the TEST OUT connector, and the HD
SDI OUT A/B connectors (when the HKSR-9001
is installed).
You can also view playback video during
recording review, rewind searches (REW), and
fast-forward searches (F FWD).
In addition, you can search for images during the
paused state by turning the ADJUST knob (jog
search). Press the PAUSE button again to return
to the paused state.

Preparing for Playback

To make audio monitor signal settings
The VTR >AUDIO Setup menu (see page 176)
allows you to make various settings related to
audio monitor signals for playback.
The procedures are basically the same as those for
making settings related to audio monitor signals
for recording.
To adjust the level of audio output to the
EARPHONES jack
Turn the LEVEL knob.
To adjust playback audio levels
The PB LEVEL item in the VTR >AUDIO Setup
menu (see page 177) allows you to adjust audio
levels separately for each channel.
Note
Playback audio levels cannot be adjusted during
recording.
The PB LEVEL settings window appears when
you select the PB LEVEL item. The subsequent
procedure is the same as steps 1 to 5 in "To set
recording audio levels" (page 88).
To set the display range of the audio level meters
See page 88.
94 Playback – Checking the Recording
To select time data to display during
playback
Proceed as follows to select the type of time data
to display during playback.
1
Display the TC Setup menu (see page
89).
2
Select TIMER SEL.
The TIMER SEL settings window appears.
(See "To select the type of time data to
display" (page 89).)
3
Turn the SELECT/ENTER dial to
select CTL, TC (timecode), or UBIT
(user bits).
CTL: Display CTL signals recorded on the
tape.
TC: Display LTC or VITC read by the
internal timecode reader.
The TCR SEL item in the TC Setup
menu allows you to determine whether
the timecode reader is to read LTC or
VITC.
UBIT: Display user bit values inserted into
the playback timecode.
4
Press the SELECT/ENTER dial.
To play back with tracking control
Tracking control can be manually operated or
automatically optimized.
To play back with manual tracking control, use
the following procedure.
1
Insert the cassette to play back and
press the PLAY button.
2
In the VTR >SYSTEM Setup menu
select SERVO >TRACKING, and press
the SELECT/ENTER dial.
A setting window opens.