Using Ac Power; Turning On The Power; Checking The Power And Voltage - Sony SRW-9000PL Operation Manual

Hd camcorder
Hide thumbs Also See for SRW-9000PL:
Table of Contents

Advertisement

1"LOCK" arrow
2Matching line on the unit
Note
If the battery pack is not attached correctly, the terminal
may be damaged.
To detach the battery pack
With the unit powered off, hold the release button
in and pull the battery pack up.
Notes
• Be careful never to remove the battery pack during
recording and playback.
• Make sure to power the unit off before replacing the
battery pack.

Using AC Power

Use an AC-DN2B/DN10 AC adaptor.
Connect a DC power cord (not supplied) to this
unit's DC IN 11-17V connector, and then connect
30
Connecting a Power Supply
Release button
the AC power cord (supplied with the AC
adaptor) to an AC power source.

Turning on the Power

Push the power ON (|)/OFF (1) switch to the ON
side. The power indicator lights when the unit is
powered on.
Power is supplied to the viewfinder connected to
the VF connector and to the lens connected to the
LENS connector, and 12 V power is supplied
from the DC OUT connector.
Push the switch to the OFF side to power the unit
off. The indicator goes out when unit is powered
off.
Notes
• To protect tapes, do not power the unit off with a
cassette loaded. Always eject the cassette before
powering the unit off.
If you do power the unit off with a cassette loaded, the
power does not go off immediately. This is to protect
the tape. The power goes off after the tape has been
returned to the unthreaded position.
• Do not remove the battery pack or disconnect the DC
power cord before the power goes off.
• After powering the unit off, wait at least two seconds
before powering it on again.
• Always make sure that the unit is powered off before
connecting accessories.

Checking the Power and Voltage

To check the type of power being used
A battery mark appears in the lower left of the
control panel display when power is being
supplied from the battery attachment section.
A power plug mark appears when an AC adaptor
is selected as the power supply.
Note that this mark does not reflect the actual type
of power being used, but reflects the settings of
the following VTR menu items.
• SYSTEM Setup >BATTERY >BATT TYPE
• SYSTEM Setup >BATTERY >DCIN TYPE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hksr-9001Hksr-9002

Table of Contents