Table of Contents
Advertisement
Viewing Settings and
Indications in the
Viewfinder
In addition to the video, the viewfinder can
display text and messages showing the settings
and operating status of the unit.
The same information can be displayed on the
monitors connected to the HD SDI MON1 and
HD SDI MON2 connectors.
Note
This information is not displayed when the unit is in
menu operation mode. Exit menu operation mode to
view the information.
Viewing the Basic Status
The following status indications can be
superimposed on the camera picture. They appear
when you press the VF MENU/DISPLAY button.
The display conditions can be specified on the
<VF DISPLAY> page of the Camera >USER
(OPERATION) menu.
a Frame rate
The current frame rate is displayed.
b Color temperature
Displays the color temperature.
c Recording mode
"REC" is displayed when the recorder docked on
the camera is in recording mode.
d Battery indication
Indicates the input power voltage.
64
Viewing Settings and Indications in the Viewfinder
The indication begins to flash if the voltage
decreases to the NEAR END value specified on
the <BATT ALARM SET> page of the Camera
>MAINTENANCE menu. The flashing becomes
quicker when the voltage decreases further and
approaches the END value. You can check the
NEAR END and END values on the <BATTERY
ALARM> page of the Camera >USER
(OPERATION) menu and on the SYSYTEM
Setup >BATTERY of the VTR menu.
e Focus position
Shows the focus position of a zoom lens as a
numeric value.
With an ARRI LDS lens: 0 to 1023
With a Cooke/i lens: 0.00 m to 999 m
May be shown in inches with some lenses:
0000000 to 9999999 (inches × 10)
f Zoom position
Indicates the approximate position of the zoom
lens variator between wide angle and telephoto.
With an ARRI LDS lens: Z0 (wide) to Z1023
(tele)
With a Cooke/i lens: Z1 (wide) to Z9999 (tele)
(focal length: 1 mm to 9999 mm)
g White balance memory
Displays the currently selected white balance
memory.
W:A: Memory A
W:B: Memory B
W:P: Preset memory
The setting is fixed at W:P in Cine or Cine-EI
mode.
In Custom mode, you can change the setting
using the subdisplay or from a remote control
unit.
h Color temperature filter mode
Indicates the state of the electrical filter.
In Cine or Cine-EI mode, "5600" is displayed
when the daylight filter is selected. When the
tungsten filter is selected, this column becomes
blank.
In Custom mode, "5600" is displayed when
5600K is set to ON.
i Optical filters
Displays the types of currently selected two
filters.
Advertisement
Table of Contents
