Assigning Functions To Assignable Buttons/Switch - Sony SRW-9000PL Operation Manual

Assigning Functions to
Assignable Buttons/Switch
You can assign functions to the following
buttons/switch: assignable buttons 1 to 3 and 5 to
8 on the right-side panel of the main unit and the
AP-1 (optional); the 4 side (top) of the assignable
4/AUTO BLK BAL switch (called "switch 4"
below) and assignable buttons N and C.
The following functions are assigned when the
unit is shipped from the factory.
Switch Function
1 OFF (no function)
2 OFF (no function)
3 OFF (no function)
4 OFF (no function)
5 STOP
6 PLAY
7 REW
8 F.FWD
N OFF (no function)
C OFF (no function)
Functions that can be assigned to assignable
buttons 1 to 3, 5 to 8, N, and C
Menu indication
ND
REC REVIEW
PB(VF/VBS)
MLUT
a)
(VFVBS)
a)
MLUT(MON)
FAN MODE
VTR SAVE
BARS
STOP
54 Basic Settings with the Subdisplay
Function
ND Switch ND filters
With REC REVIEW set to
NORM, the last part of the
recorded tape is normally
rewound for three seconds
(maximum: 10 seconds) then
played back. With REC
REVIEW set to ALL, the tape
is rewound to the recording
start position then played
back.
The video signals being
played back are output to the
viewfinder.
On/Off of the fixed ITU-R709
gamma of the viewfinder
On/Off of the fixed ITU-R709
gamma of the monitor
Switching of the fan mode
Switching of the VTR power
supply mode (SAVE, STBY)
Display color bars
Stop tape transport
Menu indication Function
REW Rewind the tape
PLAY Play the tape
F.FWD Fast forward the tape
GAIN Switch the gain position
WHITE BAL Switch the white balance
memory
GAIN-9/18dB The gain value is temporary
set to –9 dB or –18 dB (gain
drop function). Each press of
the button switches gain value
in the following order; –9 dB
t –18 dB t OFF t –9 dB
···. If the gain value is kept
unchanged from –9 dB or –18
dB, gain drop function is
cancelled.
b) Switch the setting for the
CACHE REC
Cache Rec function. Each
press of the button switches
the setting in the following
order; 25% t 50% t 75%
t 100% t Quick Rec t
OFF.
OFF None
a) When using S-LOG A
b) When an HKSR-9002 is installed
Functions that can be assigned to assignable
switch 4
Menu indication Function
AWB Automatic white balance
adjustment
BARS Color-bar indication
TEST1 Test signal output
OFF None
Note
Even if AWB is assigned to assignable switch 4, AWB
does not function in Cine and Cine-EI modes.
Assignable buttons 1 and 2 setting page
You can assign the functions of buttons 1 and 2 on
the first and second lines, respectively.