Install The Microwave Oven - Whirlpool MH3184XPB Service Manual

Roof Venting Installation Only
1. Repeat Step 1 from "Wall Venting Instal-
lation Only."
2. Repeat Step 2 from "Wall Venting Instal-
lation Only."
3. Repeat Step 3 from "Wall Venting Instal-
lation Only."
4. Repeat Step 4 from "Wall Venting Instal-
lation Only."
5. Rotate the blower motor so the exhaust
ports face the top of the microwave oven
and the flat sides of the blower motor
face the back of the microwave oven.
Lower the blower motor back into the
microwave oven.
A. Exhaust port
IMPORTANT: If blower motor is not posi-
tioned with flat sides facing the back of the
microwave oven (as shown), performance will
be poor.
6. Reattach blower motor to back of mi-
crowave oven with 2 screws removed in
Step 3 of "Wall Venting Installation Only."
Securely tighten screws.
NOTE: If blower motor is not correctly orient-
ed, the 2 screws removed in Step 3 cannot be
reattached to the microwave oven.
7.
8.
A

INSTALL THE MICROWAVE OVEN

IMPORTANT: The control side of the
microwave oven is the heavy side. Handle the
microwave oven gently.
1.
2.
2-4
Reattach damper plate. Make sure tabs
at top and back of damper plate are in-
serted fully into their respective slots in
the microwave oven.
A B C
A. Damper plate
B. Tabs at back of damper plate
C. Slots in back of microwave oven exterior
D. Damper plate tabs
E. Slots in top of microwave oven exterior
Secure damper plate with screw.
WARNING
Excessive Weight Hazard
Use two or more people to move and
install microwave oven.
Failure to do so can result in back or
other injury.
Place a washer on each 1/4-20 x 3˝ bolt
and place inside upper cabinet near the
3/8˝ (10 mm) holes.
Make sure the microwave oven door is
closed and taped shut.
D E