10.10 Automatic Telex Using Macrofile - Furuno FS-1575 Operator's Manual

DIRTLX macrofile
Sample DIRTLX macrofile

10.10 Automatic Telex Using Macrofile

This section describes how to transmit a telex message using a macrofile.
Basic procedure
1. Register an answerback code (telex number assigned by the coast station).
2. Register the coast station frequency and channel to a scan group.
3. Register the station name including the scan group name.
4. Retrieve a macrofile. Include the station name and the message file name. Type
the message and save the file.
5. Open the macro operation menu and select a macrofile. Your message will be
transmitted automatically. Below is the sequence of automatic message transmis-
sion to a coast station.
1) Search for free-signal
2) Call coast station on one of its radio channels
3) After connection is established, identity exchange
4) Transmission of service category and subscriber's address
5) Transmission of message
< [1] UNTITLED1 >
@FREE $RRR$
@CALL S:LYNGBY RADIO
@WRU
@CASE GA+?
@SEND DIRTLX725644325+
@CASE MSG+?
@SEND
A: \ABC
@SEND KKKK
@CASE GA+?
@SEND BRK+
1
Search dot pattern free signal until it is found
2 Station name (Example: LYNGBY RADIO)
Who are you?
Station identity exchange
3 Subscriber's telex number (in example, 72 is country
code of Japan) for direct dialing mode
4
Location and name of file message
A: \ABC
5 Request for termination of message
Sample DIRLTX macrofile
10. NBDP TRANSMISSION, RECEPTION
1
2
3
4
5
10-15