Furuno FS-1575 Operator's Manual page 73

5. Rotate the ENTER knob to select [DIRECT INPUT] or [ADDRESS BOOK DATA]
then push the knob.
[ADDRESS BOOK DATA]: Select an MMSI from the [ADDRESS BOOK] (see
section 6.15) then push the ENTER knob.
[DIRECT INPUT]: Enter MMSI of station, which you want to know its position, with
the numeric keys then push the ENTER knob.
6. With [DSC FREQ] selected, push the ENTER knob.
7. Rotate the ENTER knob to select DSC frequency desired then push the knob.
8. With [GO TO CALL] selected, push the ENTER knob to send the position call. The
screen changes as below.
[SENDING]
POSITION MSG
TO
After the call has been sent, the WAIT FOR ACK screen appears as below. The
elapsed time since sending the call is displayed.
[WAIT FOR ACK]
POSITION MSG
TO
When you receive an acknowledge message, the audio alarm sounds and a pop-
up message appears.
[ACKNOWLEDGED]
POSITION ACK
FROM
LAT
LON/UTC
5. DSC GENERAL MESSAGE CALLING, RECEIVING
2187.5/ RX 2187.50 kHz
ELAPSED TIME:
123456789
: CAPTAIN_5075
INFO PRINT
2187.5/ RX 2187.50 kHz
123456789
: CAPTAIN_5075
INFO PRINT HOLD
RESEND
2187.5/ RX 2187.50 kHz
ELAPSED TIME:
123456789
: CAPTAIN_5075
INFO PRINT HOLD
00 00 04
H M S
ELAPSED TIME:
00 00 12
H M S
QUIT
00 01 12
H M S
QUIT
5-21