Furuno FS-1575 Operator's Manual page 55

2) Rotate the ENTER knob to select DSC band then push the knob. One of the
menus shown below appears depending on the band selected.
2MHz: To the ship station
2MHz: To the coast station
4MHz
6MHz
3) Rotate the ENTER knob to select DSC frequency then push the knob. The
screen shows the DSC frequency band selected, at [DSC FREQ].
Urgency or safety priority
1) Rotate the ENTER knob to select [DSC FREQ] then push the knob.
2) Rotate the ENTER knob to select the frequency then push the knob.
If you change the communication frequency, go to step 11. If not, go to step 13.
11. Rotate the ENTER knob to select [COMM FREQ] then push the knob.
Note: When you send an individual call to a coast station, [COMM FREQ] is au-
tomatically set to [POSITION] or [NO INFO]. [NO INFO] lets the receiving station
set the working frequency.
12. Follow "How to set working channel, frequency" to set working channel or fre-
quency.
How to set working channel, frequency
To send a call, set the working frequency as below, to communicate with the re-
ceiving station. The working frequency can be entered by TX and RX frequencies
or channel number.
1) Rotate the ENTER knob to select [FREQUENCY] or [CHANNEL] then push
the knob.
2) Enter TX/RX frequency or channel with the numeric keys then push the EN-
TER knob.
5. DSC GENERAL MESSAGE CALLING, RECEIVING
8MHz
12MHz
16MHz
0 . 0
Frequency setting window
18MHz
22MHz
25MHz
Channel setting window
5-3