Toshiba e-STUDIO5540C Scanning Manual page 98

4 USING TEMPLATES
13
Press [SCAN].
For the models below, press [PREVIEW] in this step and then select the scan function in order to
preview your scans at the end of the operation.
- e-STUDIO6570C Series
- e-STUDIO6550C Series
- e-STUDIO4540C Series
- e-STUDIO2550C Series (only when the hard disk is installed)
- e-STUDIO5055C Series
- e-STUDIO507 Series
- e-STUDIO857 Series
For instructions on how to do so, see the following section:
 P.62 "Previewing Scans"
14
If the screen below appears, place another original on the original glass and press
[SCAN] or the [START] button to continue scanning. To finish the job, press [JOB
FINISH], followed by the [FUNCTION CLEAR] button.
 The above screen is not displayed under the following conditions:
- You scan the original from the Reversing Automatic Document Feeder
[CONTINUE] to scan additional originals.
- A scan preview is displayed.
 To cancel the operation, press [JOB CANCEL].
 To change the scan settings, press [SCAN SETTING].
 P.50 "Changing Scan Settings"
* The Reversing Automatic Document Feeder is optional for e-STUDIO4540C Series, e-STUDIO507 Series, e-STUDIO456
Series, e-STUDIO2550C Series, e-STUDIO5055C Series, e-STUDIO307LP and e-STUDIO306LP.
96 Using Scan Templates
*
without pressing