Chauvet Rogue R2 Quick Reference Manual page 3

Rogue™ R2 Beam QRG EN
Lamp 1. Turn the fixture off and disconnect it from power.
2. Wait at least 15 minutes for the lamp to cool down.
Replacement
3. Remove both head covers by removing 8 Phillips-head ¼-turn screws.
4. Orient the rear of the product so that the fan is facing upward.
5. Remove the 2 Phillips-head screws on the sides of the fan assembly.
6. Roll the fan assembly to the right to expose the lamp.
7. Using the lamp base, push the lamp down against the spring clips located on the
bottom, then roll the lamp out the top.
8. Remove the 2 wires connected to the lamp by the spade connectors.
9. Reverse the steps above to install the new lamp.
Please refer to the User Manual for more detailed instructions with images.
¼-turn
Phillips-head
screws
3