Table of Contents
Advertisement
Available languages
Available languages
Rogue™ R2 Beam QRG
About This Guide
Disclaimer
Safety Notes
Contact
What Is
Included
AC Power
AC Plug
Replacing The Fuse
The Rogue™ R2 Beam Quick Reference Guide (QRG) has basic product
information such as connection, mounting, menu options, and DMX values.
Download the User Manual from
The information and specifications contained in this QRG are subject to change
without notice.
·
DO NOT open this product. It contains no user-serviceable parts.
·
DO NOT look at the light source when the product is on.
·
CAUTION: This product's housing may be hot when lights are operating.
·
Mount this product in a location with adequate ventilation, at least
20 in (50 cm) from adjacent surfaces.
·
DO NOT leave any flammable material within 50 cm of this product while
operating or connected to power.
·
USE a safety cable when mounting this product overhead.
·
DO NOT operate this product outdoors or in any location where dust,
excessive heat, water, or humidity may affect it. (IP20)
·
DO NOT operate this product if the housing, lenses, or cables appear
damaged.
·
DO NOT connect this product to a dimmer or rheostat.
·
ONLY connect this product to a grounded and protected circuit.
·
ONLY use the mounting brackets or the handles to carry this product. Do not
carry by the moving head.
·
In the event of a serious operating problem, stop using immediately.
·
The maximum ambient temperature is 113 °F (45 °C). Do not operate this
product at higher temperatures.
Outside the U.S., United Kingdom, Ireland, or Mexico, contact your distributor to
request support or return a product. From inside the U.S., UK, Ireland, or Mexico,
use the information in
·
Rogue™ R2 Beam
·
Neutrik® powerCON® power cord
·
2 Omega brackets with mounting hardware
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
www.chauvetprofessional.com
Contact Us
at the end of this QRG.
Wire (U.S.)
Black
White
Green/Yellow
2
for more details.
·
Warranty Card
·
Quick Reference Guide
Wire (Europe)
Screw Color
Brown
Yellow/Brass
Blue
Green/Yellow
EN
Silver
Green
Advertisement
Table of Contents
