Assembling Your Blender; Assembly Of Container; Tightening The Container - Oster Osterizer Recipes And Instructions

CAUTION: Follow these important steps to assemble, tighten, and mount blender container
quickly and correctly. INJURY MAY RESULT IF MOVING BLADES ARE ACCIDENTALLY EXPOSED

ASSEMBLY OF CONTAINER

side down so the small
opening is at the top.

TIGHTENING THE CONTAINER

1. To tighten contain-
bied container se-
base ring with handle
and lug In front of the
right stop.
Do not attempt to place the container on, OI
remove from the motor base while
the motor is running.
ALWAYS HOLD CONTAINER WITH ONE HAND WHILE PROCESSING. "MINI-BLEND" JARS
"Mini-Blend" jars 8 ounce [1250
blender). For proper assembly and tightening instructions, see above directions. The "Mini-Blend" jars allow for the pro-
cessing and storing of foods in the same container
DO NOT USE OTHER TYPES OF JARS FOR PROCESSING
FOODS. Ordinary jars may break or unscrew during pro-
cessing. Do not wash any parts, including container, in an
automatic dishwasher. DO NOT fill "Mini-Blend" jar above
MAXIMUM FILL LINE to allow for expansion of foods while
processing. Overfilling may cause the jar to break and could
result in injury.

Assembling Your Blender

2. Place sealing ring
on container opening.
2. Using container
handle, turn contain-
er to the left as far as
possible. This insures
that the container
bottom is tightened
properly. Remove
container from motor
base and mount.
3. Turn the agitator
blades upside down
and place in mouth of
container.
1. To operate blend-
er, place assembled
container in motor
base ring with con-
tainer lug against flat
side of the motor
base stop. If contain-
er lug does not rest
against flat side of
right stop, remove
container assembly
and place against flat
side of left stop. Seat
container firmly and
operate.
5
4. Thread container
bottom to container.
Engage threads prop-
erly. Screw on firmly.
2. To remove con-
tainer, lift straight up. (If
it is not easily removed,
rock gently and lift up.
do not twist.) If con-
tainer bottom cannot be
loosened by hand, place
assembled container
into motor base ring
with handle in from of
left side stop. Using
handle, turn container
to right until container
bottom loosens
normally included with your