Assembling Your Blender - Oster BLSTTG-PB0 Instruction Manual

ASSEMBLING YOUR BLENDER

CAUTION: Follow these important steps to assemble, tighten, and mount Blender jar
quickly and correctly. INJURY MAY ReSULT IF MOVING BLADeS ARe eXPOSeD.
1.
1. Turn jar upside down so the small opening
is at the top.
2. Place sealing ring on jar opening.
L
eft
S
top
ALWAYS HOLD JAR WITH ONE HAND WHILE PROCESSINg!
2.
TIGHTENING THE JAR
A B
R
ight
S
top
J
aR
L
ug
M
otoR
B
aSe
C D
3.
3. Turn the blade blades upside down
and place in mouth of jar.
4. Thread jar bottom to jar.
A. To tighten jar bottom, put assembled jar
securely into motor base ring with handle
and lug in front of the right stop.
b. Using jar handle, turn jar to the left as
far as possible. This insures that the jar
bottom is tightened properly. Remove jar
from motor base and mount.
C. To operate Blender, place assembled jar
in motor base ring with jar lug against
flat side of the motor base stop. If jar lug
does not rest against flat side of right stop,
remove jar assembly and place against
flat side of left stop. Seat jar firmly and
operate.
D. To remove jar, lift straight up. (If it is not
easily removed, rock gently and lift up, do
not twist). If jar bottom cannot be loosened
by hand, place assembled jar into motor
base ring with handle in front of left side
stop. Using handle, turn jar to right until jar
bottom loosens.
Do not attempt to place the jar on or
attempt to remove it from the motor base
while the motor is running.
E ng li s h -5
4.