Advertisement
NOTE: Oster blender comes with a thermal resettable fuse to
prevent the motor from damaging. In the case of an extreme
overload, the appliance shuts off. Turn the control knob to
" 0" and unplug it. Let it cool for at least 90 minutes before
continuing.
POWER CORD INSTRUCTIONS
Please follow the instructions below to ensure the safe use of the power cord.
• DO NOT use an extension cord with this product.
• DO NOT pull, twist or otherwise abuse the power cord.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard. Please call the Consumer Service number
as listed at the back of this user manual.
KNOWING YOUR OSTER®
BLENDER
Cover
The cover for your OSTER ® Blender consists of two
parts, the flip tab (1) and the cover (2). The cover is
self-sealing and is resistant to absorption of odors and
stains. The flip tab gives convenience for easy pouring
and opening.
Glass Jar
The glass jar (3) for the Blender is graduated for
easy measurement and is molded with heat and cold
resistant material. The handle and special lid design
gives easy removal of liquid mixtures.
Threaded Bottom Cap
Threaded Bottom Cap (4) with Ice Crush Blade
pulverizes ice for smooth frozen drinks.
Motor and Motor Base
The powerful 2-speed motor is the heart of the
appliance and is a dedicated design for Oster blender.
It is completely enclosed within the housing (5).
The motor uses a "free-floating" feature to reduce
noise and wear. This allows the square post which
protrudes from the motor base to move slightly
from side to side. To prevent the motor from being
overloaded, read this instruction manual carefully and
follow the instructions.
Speed Control
This blender has 2 speed settings: Low (I)-High (II).
Operate (6) at High on toughest ingredients and
achieve the finest result.
NOTE: DO NOT operate blender at any setting
continuously for more than 3 minutes.
1
4
6
4
ASSEMBLING YOUR BLENDER
CAUTION: Follow these important steps to assemble, tighten and mount glass jar quickly and
correctly. INJURY MAY RESULT IF MOVING BLADES ARE EXPOSED.
1.
1. Turn jar upside down so the small opening
is at the top.
2
3
A
B
L
eft
R
ight
S
top
S
top
M
otoR
B
aSe
5
C
D
2.
2. Place Threaded Bottom Cap on Jar and
turn it clockwise to tighten.
3. Place Jar assembly onto base.
TIGHTENING THE JAR
A. To tighten jar bottom, put assembled jar
securely into motor base ring with handle
in front of the right stop.
B. Using the jar handle, turn jar to the left as
far as possible. This insures that the jar
bottom is tightened properly. Remove jar
from motor base and mount.
C. To operate Blender, place assembled jar
in motor base ring. Seat jar firmly and
operate.
D. To remove jar, lift straight up. (If it is not
easily removed, rock gently and lift up, do
not twist). If jar bottom cannot be loosened
by hand, place assembled jar into motor
base ring with handle in front of left side
stop. Using handle, turn jar to right until jar
bottom loosens.
Do not attempt to place the jar on or
attempt to remove it from the motor base
while the motor is running.
ALWAYS HOLD JAR WITH ONE
HAND WHILE PROCESSING!
5
3.
Advertisement
