Making Coffee Using Pre-Ground Coffee; Making Cappuccino And Milk Based Drinks; Filling And Attaching The Milk Container; Adjusting The Amount Of Froth - DeLonghi ECAM22.360 Instructions For Use Manual

SHORT
RISTRETTO
5. Preparation begins and information on the coffee selected
is displayed.
Once the coffee has been made, the appliance is ready to be
used again.
Please note :
• while the machine is making coffee, delivery can be inter-
rupted at any moment by pressing one of the coffee but-
tons.
• At the end of delivery, to increase the quantity of coffee in
the cup, within 3 seconds, press and hold one of the coffee
buttons.
Please note :
For hotter coffee, see the section "Tips for a hotter coffee".
Important!
• If the coffee is delivered in drops, too weak and not creamy
enough or too cold, read the tips in the "Troubleshooting"
section on page 19.
• Various alarm messages could be displayed while using
the machine. Their meaning is explained in the section
"Displayed messages" (page 18).

Making coffee using pre-ground coffee

Important!
• Never place coffee beans in the pre-ground coffee funnel
as this could damage the appliance.
• Never add pre-ground coffee
when the machine is off or it
could spread through the inside
of the machine and dirty it. This
could damage the appliance.
• Never use more than one level measure as it could dirty
the inside of the machine or block the funnel.
Please note :
When you use pre-ground coffee, you can only make one cup
of coffee at a time.
1. Make sure the appliance is on.
2. Press the button.
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig. 13).
4. Place a cup under the coffee spouts.
5. Press the corresponding one cup coffee button (
).
6. Preparation begins.
MAKING CAPPUCCINO AND MILK BASED
DRINKS
LONG
LUNGO
•

Filling and attaching the milk container

1. Remove the lid (fig. 14);
2. Fill the milk container with a sufficient quantity of milk,
•
•
3. Make sure the milk intake tube is correctly inserted in the
4. Place the lid back on the milk container.
5. Remove the hot water spout from the nozzle.
6. Attach the container to the nozzle, pushing as far as it will
7. Place a sufficiently large cup under the coffee spouts
8. Follow the instructions below for each function.

Adjusting the amount of froth

Turn the froth adjustment dial on the milk container lid to ad-
just the amount of froth on the milk delivered while making
cappuccinos and milk-based drinks.
Dial
position
or
12
Please note!
To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid and hot water nozzle
as described in the section "Cleaning the milk container"
on pages 13 and 15.
not exceeding the MAX level marked on the handle (fig.
15). Each mark on the side of the container corresponds to
100 ml of milk.
Please note!
For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
If "Energy saving" mode is enabled, you may have to wait
a few seconds before the drink is delivered.
bottom of the milk container lid (fig. 16).
go (fig. 17).
and the frothed milk spout. Adjust the length of the milk
spout. To move it nearer the cup, simply pull it downwards
(fig. 18).
Description
No froth
Min. froth
Max. froth
Recommended for...
caffelatte/hot milk (without
froth)
Macchiato
CAPPUCCINO/FROTHED
MILK