Replacing The Filter; Removing The Filter; Technical Data; Disposal - DeLonghi ECAM22.360 Instructions For Use Manual

The filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last a maximum of three weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in the figure until water comes out of the
openings at the side for more than a minute (fig. 30).
4. Extract the tank from the appliance and fill with water.
5. Insert the filter in the water tank and immerse it com-
pletely for about ten seconds, sloping it to enable the air
bubbles to escape (fig. 31).
6. Insert the filter in the filter housing (fig. 32A) and press as
far as it will go.
7. Close the tank with the lid (fig. 32B), then replace the tank
in the machine.
When you install the filter you must notify the appliance of its
presence.
8. Press the MENU button to enter the menu;
9. Press the or
ter" is displayed.
10. Press the button.
11. "Enable?" is displayed.
12. Press the button to confirm the selection. "HOT WA-
TER Confirm?" is displayed.
13. Position a container with a minimum capacity of 100 ml
under the spout.
14. Press the button to confirm the selection. The
appliance begins hot water delivery and the message
"Please wait" is displayed.
15. After delivery, the appliance returns automatically to the
"Ready for coffee" position.
The new filter is active and indicated by an asterisk displayed
under "Install filter" in the menu. you can now use the appli-
ance.

Replacing the filter

When "REPLACE FILTER" is displayed, after two months (see
date indicator) or when the appliance has not been used for 3
weeks, you should replace the filter:
1. Extract the tank and exhausted filter;
2. Take the new filter out of its packet and proceed as illus-
trated in points 3, 4, 5 and 6 in the previous section.
3. Position a container with a minimum capacity of 100 ml
under the spout.
4. Press the MENU button to enter the menu;
5. Press the or
filter" is displayed.
10. Press the button;
11. The message "Confirm?" is now displayed;
12. Press the button to confirm the selection;
13. "HOT WATER Confirm" is displayed;
14. Press the button to confirm the selection. The
button repeatedly until "Install fil-
button repeatedly until "Replace
appliance begins hot water delivery and the message
"Please wait" is displayed.
15. After delivery, the appliance returns automatically to the
"Ready for coffee" position.
The new filter is now active and you can use the coffee ma-
chine.

Removing the filter

If you want to use the appliance without the filter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Extract the tank and exhausted filter;
2. Press the MENU button to enter the menu;
3. Press the or
filter*" is displayed;
4. Press the
5. The message "Confirm?" is now displayed;
6. Press the
to exit the menu.

TECHNICAL DATA

Voltage:
Absorbed power:
Pressure:
Water tank capacity:
Size LxHxD:
Cable length:
Weight:
Coffee beans container capacity:
The appliance complies with the following EU directives:
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amend-
ments
• EC Regulation 1275/2008 for standby
• Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.

DISPOSAL

In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with house-
hold waste, but taken to an authorised waste sepa-
ration and recycling centre.
17
button repeatedly until "Remove
button;
button to confirm and the MENU button
220-240 V~ 50/60 Hz max. 10A
1.8 litres max.
238x345x430 mm
250 g max
1450W
15 bars
1,15 m
9,1 Kg