Switching Off In An Emergency - Fujitsu SE700 Operating Manual

Switching the SE300 on and off

8.1.1 Switching off in an emergency

The SE300 complies with the relevant safety regulations for IT equipment, including
electrical office equipment.
In an emergency all the hardware components must immediately be disconnected by
cutting off the power distribution units from the power source (e.g. when the housing or
power cable is damaged or liquid or foreign material gets into the equipment).
v
If despite the emergency there is still time enough, you can also switch off Server Unit(s),
Application Unit(s) and Management Unit manually via the operating panel at the front of
the unit (for the MU see
x86" [3] and "Additive Components" Operating Manuals [4]). Optional hardware compo-
nents have their own On/Off switches or are switched on/off automatically together with the
Server Unit (e.g. ETERNUS JX40, see "Additive Components" [4]).
v
66
CAUTION!
Operation of the SE server SE300 is then terminated ungracefully and abruptly.
Notify Customer Support.
figure 10 on page
CAUTION!
These do not disconnect the hardware components completely from the power
source. To cut the entire system off from the power source, you must must
disconnect the power distribution units from the power source.
Notify Customer Support.
Switching the server on and off
49, and for the SU and AU see the "Server Unit
U41858-J-Z126-1-76