Figure 5-16. Vor Discrete Inputs Page; Figure 5-17. Vor/Loc/Gs Cdi Page - Garmin GPS 400W, GNC 420W Installation Manual

5.3.13 VOR DISCRETE INPUTS Page (GNS 430W
Only)
Select the VOR DISCRETE INPUTS Page (see Figure 5-16).
This page allows you to verify the operation of an external
VLOC transfer switch that may be present in the installation.
Selection
REMOTE XFR
5.3.14 VOR/LOC/GS CDI Page (GNS 430W Only)
Select the VOR/LOC/GS CDI Page (see Figure 5-17).
This page allows you to verify and calibrate the CDI outputs,
both lateral (LAT) and vertical (VERT) from the
VOR/LOC/Glideslope receiver, as well as the OBS resolver
input to the VOR receiver. It also allows you to select the format
for DME tuning data. Using the controls on the GNS 430W
front panel, make the selections below and verify the interfaces
as appropriate:
The LAT, VERT, and SELECTED COURSE configurations only apply to installations
where a CDI/HSI is connected to the VOR/LOC/GLIDESLOPE pins on connector
P4006.
CDI (LAT/VERT)
Selection
Max left
Full left
Std. left
Center
Std. right
Full right
Max right
FLAG (LAT/VERT)
Selection
Hide
View
S-FLG (LAT/VERT)
Selection
Hide
View
Page 5-16
Rev. E
Verify That:
The box is filled in while a remote VLOC transfer switch is pressed.
Verify That:
The CDI is "pegged" to the left/up.
The CDI is deflected full scale to the left/up.
The CDI is deflected left of center.
The CDI is centered.
The CDI is deflected right of center.
The CDI is deflected full scale to the right/down.
The CDI is "pegged" to the right/down.
Verify That:
The LAT/VERT flag is hidden.
The LAT/VERT flag is in view.
Verify That:
The LAT/VERT superflag is hidden.
The LAT/VERT superflag is in view.

Figure 5-17. VOR/LOC/GS CDI Page

NOTE
Figure 5-16. VOR DISCRETE
INPUTS Page
400W Series Installation Manual
190-00356-02