Cisco SPA232D Administration Manual page 173

Configuring the Voice Settings
DECT Line 1 - DECT Line 10
Cisco SPA232D Administration Guide
Field
Cfwd No Ans
Delay
Supplementary Service Settings
Field
Secure Call
Setting
Message Waiting
Description
Delay in sec before Call Forward No Answer triggers.
Same as Cfwd All Dest.
Default setting: 20
Description
If yes, all outbound calls are secure calls by default,
without requiring the user to dial a star code first.
Default setting: no
• If Secure Call Setting is set to yes, all outbound
calls are secure. However, a user can disable
security for a call by dialing *19 before dialing the
target number.
• If Secure Call Setting is set to No, the user can
make a secure outbound call by dialing *18 before
dialing the target number.
• A user cannot force inbound calls to be secure or
not secure; that depends on whether the caller has
security enabled or not.
Note: This setting is applicable only if Secure Call Serv is
set to yes on the line interface. See
(PHONE Port), page
Setting this value to yes can activate stutter tone and
VMWI signal. This parameter is stored in long term
memory and will survive after reboot or power cycle.
Default setting: no
Line 1 Settings
100.
4
172