Standby Mode - Plustek SmartOffice PL2546 User Manual

The following describes how to calibrate the scanner:
1. The Calibration Sheet, marked with an arrow on either edge at both sides, is
used specially for ADF Scanning calibration.
2. Insert the special calibration sheet into the ADF of the scanner, with an arrow
toward the scanner buttons.
Attention
3. Click Start > All Programs > Your scanner model name > Calibration
Wizard.
4. Click Next from the Calibration Wizard that pops up and then click Calibrate
Now.... Start to begin the Flatbed Reflective calibration process. After the
calibration is complete, click OK.
5. Click Calibrate Now.... Click on the Start button to begin the ADF calibration
process.
6. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK and then
click Finish.
S M
TANDBY ODE
To save power consumption, the scanner will enter the standby mode after it is idle
for a while. You may disable the standby mode or define an idle time for the scanner to
automatically enter the standby mode.
5
This function may or may not be available depending on the scanner model you purchase.
Please insert the special calibration sheet
included with the scanner.
may also use any plain white sheet of paper
sized in A4 (216 by 297 mm) instead; however,
the calibration effect may be less good than the
special calibration sheet.
5
36
Alternatively you