Step 2. Installing The Software - Plustek SmartOffice PL2546 User Manual

1. Plug the AC adapter into the scanner's power receptor
2. Plug the other end of the AC adapter into a standard AC power outlet.
3. Plug the square end of the included USB cable to the USB port
the scanner.
4. Plug the rectangular end of the USB cable to an available USB port on your
computer.
5. If you plan to connect your scanner to a USB hub
connected to the USB port in your computer. Next, connect the scanner to the
USB hub.
S t e p 2 . I n s t a l
S t e p 2 . I n s t a l
1. Switch on the scanner power from the rear of the scanner.
2. If the USB components on your computer are functioning correctly, they will
automatically detect the scanner causing the Add New Hardware Wizard or
Found New Hardware Wizard to be launched.
Information
3. For Windows 2000:
a. Click the Next button when the "Add New Hardware Wizard" window is
displayed.
b. Select Search for the Best Driver for Your Device [Recommended] and
click the Next button.
c. The next window will ask you where to search to find the drive. Select CD-
ROM drive, and deselect Floppy disk drives if it is checked.
d. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive and then click the Next button.
e. Click the Next button in the window that appears.
f. During the process of the installation, a message "Digital Signature required"
might be prompted. Please ignore it, and click the Yes button to continue the
installation without any misgiving at your scanner functioning. Afterwards,
please skip to procedure 8.
4. For Windows XP:
a. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive.
4
The USB hub is not included with the scanner.
l i n g t h e S o f t w a
l i n g t h e S o f t w a
If your computer is off when the scanner is
connected, the "Add New Hardware Wizard"
message will not be displayed until the
computer is on and Windows starts.
4
, make sure that the hub is
r e
r e
10
.
at the rear of