Replacing The Service Doors - HP J8K44PA User Manual

1. Remove the battery (see
2. With the battery bay away from you, loosen the service door screw (1). The service door screw
secures both service doors.
3. Slide the larger service door away from the battery bay (2) to remove it.
4. Slide the smaller service door away from the battery bay (3) to release it, and then lift the service
door (4) to remove it.
NOTE:

Replacing the service doors

Replace the service doors after accessing the memory module slot, hard drive, regulatory label, and
other components.
1. With the battery bay away from you, replace the smaller service door first. Align the vent on the
smaller service door with the vent on the computer, and then slide it toward the battery bay (1).
2. Press down on the smaller service door (2) until it snaps into place.
3. Slide the larger service door toward the battery bay (3) until it snaps into place.
58 Chapter 8 Drives
Inserting or removing the battery on page
Your computer may look slightly different from the illustration in this section.
48).