Assembly - Bounty Hunter Platinum Owner's Manual

ASSEMBLY

G
Position S-Rod upright.
1
G
Rotate the LOCKING COLLAR fully in the
2
counterclockwise direction.
G
Insert your finger inside the tube and make sure the
3
INTERNAL CAM LOCK is flush with the inside of the tube.
S-ROD
G
5
G
Insert the MIDDLE STEM into the S-ROD,
4
with the SILVER BUTTON pointed upward
G
Rotate the MIDDLE STEM until the SILVER
5
BUTTON locates in the hole.
G
Twist the LOCKING COLLAR fully in the
6
clockwise direction until it locks.
G
Repeat this process on the LOWER STEM.
7
G
Using the BOLT and KNURLED KNOB,
8
attach the SEARCHCOIL to the LOWER
STEM.
G
Adjust the LOWER STEM to a length that lets
9
you maintain a comfortable upright posture, with
your arm relaxed at your side, and the SEARCHCOIL
parallel to the ground in front of you.
G
Wind the CABLE securely around the STEMS.
1 0
G
Connect CABLE PLUG to housing.
11
Do not twist the Cable or Plug. Turn Locking Ring only.
Use minimal finger pressure to start the threads. Do
not cross-thread. When the Locking Ring is fully
engaged over the threaded connector, give it a firm turn
to make sure that it is very tight. When the Locking
Ring is fully engaged over the threaded connector, it
may not cover all of the threads.
G
Tighten both LOCKING COLLARS.
1 2
*
Note: Very tall users can purchase the optional Extended Lower Stem (TUBE5X), for extended reach.
4
Caution:
LOCKING
COLLAR
SILVER BUTTON
S-ROD
MIDDLE STEM
Forcing in MIDDLE STEM with CAM LOCK raised may form a burr on
camlock. If this happens, remove burr with knife to allow insertion.
G
2
INTERNAL
G
3
CAM LOCK
G
MIDDLE
4
STEM
G
4