Of Tones; Volume; Pull-Tab; S-Cap - Bounty Hunter Platinum Owner's Manual

OPERATION and CONTROLS
MENU SELECTIONS

4. # OF TONES

While the # OF TONES line is highlighted, use
the number of different audio tones.
Different target categories are identified by different audio tones in order
to give you the fastest real-time reference while searching. Most
experienced users become familiar with the tones and search without
always looking at the display.
Use this selection to program the number of audible tones the detector will emit.
The default setting is 4 tones.
If you program less than 4 tones, the tones, by category, are as outlined here:
# Tones Iron Foil
1 Low Low
2 Bass Low
3 Bass Medium Medium Medium Medium Medium High High
4 Bass Low

5. VOLUME

While the VOLUME line is highlighted, use
speaker volume.
The default volume setting is 10. Maximum is 10.
Minimum is 0 (volume off). At levels 1, 2 and 3, high tones will be
inaudible or barely audible.
The speaker volume will diminish as battery voltage drops.
maximum speaker volume, use 1 or 2 tones, as the low and bass tones
generate the loudest sounds.
Volume can be set while in either the DISCRIMINATION or ALL METAL
Modes, but only one setting applies to both modes. Volume in the two
modes cannot be set independently.
continued
Nickel Pull-Tab SCAP
Low Low
Low Low
Low Medium Medium Medium High High
and
Zinc
Low Low
Low Low
and
cont.
to program
Dime Qtr+
Low Low
Low Low
to change the
For
15