Table of Contents
Advertisement
SSEMBLY
Assembly is easy and requires no tools.
1
Position the lower stem
with the silver button toward the back.
Using the bolt and knurled knob, attach
the search coil to the plastic extension
protruding from the lower stem.
2
If your model is equipped with a
3-piece stem, open the plastic
locking nut on the
upper tube by
rotating it
counterclockwise.
Then slide the middle
tube into the upper
tube, inserting the
silver button into the
locating hole
which is 1/2" behind the plastic locking nut. Now tighten the
plastic locking nut.
3
Press the button on the upper end of the lower stem, and
slide the lower stem into the upper stem.
Adjust the stem to a length that lets
you maintain a comfortable upright
posture, with your arm relaxed at
your side, and the search coil
parallel to the ground in front of you.
4
Wind the cable securely around the
stem.
5
Insert the plug into the matching
connector on the right underside of
the detector body. Be sure that the
key-way
correctly.
Caution:
Do not force the plug in. Excess
force will cause damage.
To disconnect the cable, pull
on the plug.
Do not pull
4
and pins line up
Connector
on back of
control housing
Advertisement
Table of Contents
